REMOVING THE FREEZER DRAWER
The freezer drawer can be removed, if needed, to fit
through tight areas.
Read these instructions completely and carefully.
REMOVE THE BASKET
1
A
Open the freezer drawer until it stops.
Lift the freezer caddy up
B
Pull the divider forward until the rear locating tabs
C
are out of the slots. Turn the divider slightly to the
side to release the front locating tabs and lift out.
The freezer basket rests on the metal slide
D
brackets and is held in place with swing locks.
Turn the swing locks from vertical to horizontal
E
position. Open refrigerator doors.
F
Lift the basket up and rotate it toward you.
Slide out from the side of the drawer.
REMOVE THE DRAWER FRONT FROM
2
THE SLIDES
A
Remove the hex-head screw from each side
of the rail assembly.
B
Tilt the drawer front toward the refrigerator
and lift out.
Set the drawer front on a non-scratching
C
surface.
Push the rail assemblies back into the cabinet.
D
Installation Instructions
.
A
(on some models)
REMOVE THE BASE GRILLE
3
(if needed)
If, after removing the freezer drawer and
refrigerator door, the refrigerator will still not fit
through a doorway, the base grille can be
removed.
A
Remove the 2 Phillips-head screws on either
side of the base grille.
Pull the grille straight out.
B
25