Removing And Installing The Freezer Drawer (Some Models) - GE Profile PDCF1NBW Technical Service Manual

5 5
REHANG REFRIGERATOR DOORS (CONT.)
2
E Make sure the gasket on the door is
flush against the cabinet and is not folded.
Make sure the door is straight and the gap
between the doors is even across the front.
While holding the aligned door in place,
tighten the top hinge bolts. Replace the
hinge cover and screw.
Hinge Cover
Top Hinge Bolts
(appearance may vary)
6 6
REPLACE OPPOSITE DOOR
3
Follow the same procedure on the
opposite door. There is no water line or
hinge cover.
7 7 ALIGN DOUBLE DOORS
4
If the top of the doors are uneven, first
try to raise the lowest door by turning the
leveling leg on the same side as the door
until the doors are even. If the unit rocks,
re-adjust the leveling legs to the extent
that the unit is stable.
If the doors remain uneven, turn the
adjustable pin to raise, or lower, the left
door to match the right door. Use a 1/4"
Allen wrench to turn the pin.
8 8
5 REPLACE FREEZER DRAWER
Refer to the Replacing the Freezer Drawer
section for instructions.
2
Adjustable pin
– 18 –
Removing and Installing the Freezer Drawer
(Some Models)
REMOVE THE BASKET
1
A Open the freezer drawer until it stops.
B
Cut the 2 wire ties off of the basket with
wire cutters.
C The freezer basket rests inside 4 tabs on
the freezer slides. Lift the basket up and
out of the 4 tabs.
D Tilt the front up and lift the entire basket
up and out of the drawer.
REMOVE THE DRAWER FRONT
2
FROM THE SLIDES
A Remove the 10 hex head screws from the
door and remove the door.
DO NOT remove the torx screws
from the rail assemblies.
DO NOT remove
torx screws
Rail Assembly
B Set the drawer front on a non-scratching
surface.
C Push the rail assemblies back into the
cabinet.
A
(Continued next page)