Replacing The Freezer Drawer - GE 200D9366P020 Owner's Manual And Installation Instructions

REPLACING THE FREEZER DRAWER

Two people may be required to complete
this procedure.
REPLACE THE BASE GRILLE
1
(if removed earlier)
CAUTION:
overtighten the screws since this may crack
the grille.
Align the base grille and replace the 2 Phillips-
head screws on either side of the base grille.
ATTACH AND SECURE THE DRAWER
2
FRONT TO THE SLIDES
Pull out the rail assemblies to the full length on
A
each side of the cabinet.
B There are two tabs on each drawer rail and
two slots on each rail assembly on the
refrigerator. Align the drawer rails with the rail
assemblies, tilt the drawer toward the
refrigerator, and seat the tabs into the slots of
the rail assembly. Lower the drawer into
position.
Installation Instructions
Be careful not to
(on some models)
ATTACH AND SECURE THE DRAWER
2
FRONT TO THE SLIDES (CONT.)
Replace the hex-head screws to secure
C
the drawer.
REPLACE THE FREEZER BASKET
3
Tilt the basket forward and lower it into the
A
drawer.
Lower the freezer caddy ensuring the hook fits over
B
the front edge of the bottom freezer basket. Push
down to secure.
Seat the basket onto the metal slide brackets and
C
over the swing locks.
Turn the swing locks from horizontal to vertical
D
position to lock the basket in place.
Turn the divider slightly to one side so the tabs
E
on the front fit into the vent slots on the basket.
Position the divider so the back locating tabs snap
into place in the back vent slots.
26