GE RADIANT PB975 Owner's Manual page 8

Usingthe surface units.
Be sure you turn flTecontrol knob to
OFF when you finish cooking.
How to Set
Push the knob in and turn in either
direction to tile setting you want.
At both
OFFand HI
the control
clicks into position. You may hear
slight
clicking
sounds during cooking,
indicating the control is keeping the
power level you set.
A HOTSURFACE
indicator light, on the
cooktop, will glow when any radiant
element is turned on. It will remain
on tmfil the sm_hce is cooled to
approximately 150°K
Hot surface iudicator light will:
come on when the unit ishot to the touch.
stay on evenafter the unit is turned off
glow until the unit is cooled to approximately
150°E
FRONT - - BRIDGE
BURNER_ BURNER
\ !
LO LO
FRONT
Using the Bridge Burner (on some models)
To use tile bridge burnex; turn tile
leli fl'ont control knob to the BRIDGE
BURNER settings.
For flfll bridge surtilce unit operation,
also mrn on tile left rear SUltilce unit.
To use only tile fl'ont suI_hce unit, turI_
tile control knob to tile
FRONTBURNER
settin ,s
Tri-RingSurface Element (onsomemodels)
Thefront right surfaceelement offers 3 cooking
areas to match the sl2e of the cookwareyou
are using.
To use tile largest cooking area, push in
and turn tile SELECTOR knob to 12". Push
and turn tile control knob to tile desired
setfin ,
To use tile smallest cooking area, mrn
tile SELECTOR knob to 6".
Push and turn
the control knob to the desired setting.
This will actiw_te only the smallest inside
heating area.
To use tile medium
cooking area, press
and turn
tile SELECTOR knob to 9". Push
down and turn tile control knob to tile
desired setting.
8