Hitachi ic35l060avv207-0 - Deskstar 60 GB Hard Drive Specifications page 158

Error data structure: Data format of error data structure is shown below.
Reserved
Error register
Sector count register (7:0)
Sector count register (15:8)
Sector number register (7:0)
Sector number register (15:8)
Cylinder Low register (7:0)
Cylinder Low register (15:8)
Cylinder High register (7:0)
Cylinder High register (15:8)
Device/Head register
Status register
Extended error data (vendor specific)
State
Life timestamp (hours)
Figure 122. Error data structure
Note: bits (7:0) refer to the contents if the register is read with bit 7 of the Device Control register cleared
to zero. Bits (15:8) refer to the contents if the register is read with bit 7 of the Device Control register set
to one.
State shall contain a value indicating the state of the device when the command was issued to the device
or the reset occurred as described below.
Value
x0h
x1h
x2h
x3h
x4h
x5h-xAh
xBh-xFh
11.18.2.4 Device error count
This field shall contain the total number of errors attributable to the device that have been reported by the
device during the life of the device. This count shall not include errors attributed to the receipt of faulty
commands such as commands codes not implemented by the device or requests with invalid parameters
or invalid addresses. If the maximum value for this field is reached the count shall remain at the maximum
value when additional errors are encountered and logged.
Description
Unknown
Sleep
Standby
Active/Idle
SMART Off-line or Self-test
Reserved
Vendor specific
Note: The value of x is vendor specific.
Deskstar 180GXP hard disk drive specifications
144
Bytes
(see Note)
(see Note)
State
Offset
1 00h
1 01h
1 02h
1 03h
1 04h
1 05h
1 06h
1 07h
1 08h
1 09h
1 0Ah
1 0Bh
19 0Ch
1 1Fh
2 20h
34