Figure 158. Log Sector Addresses - Hitachi ic35l060avv207-0 - Deskstar 60 GB Hard Drive Specifications

11.42.1.6 SMART Read Log Sector (Subcommand D5h)
This command returns the specified log sector contents to the host.
The 512 bytes data are returned at a command and the Sector Count value shall be set to one. The
Sector Number shall be set to specify the log sector address.
Log sector address
00h
01h
03h
06h
07h
80h-9Fh

Figure 158. Log sector addresses

Note: Log addresses 03h and 07h are used by the Read Log Ext and Write Log Ext commands. If these
log addresses are used with the SMART Read Log Sector command, the device shall return command
aborted.
11.42.1.7 SMART Write Log Sector (Subcommand D6h)
This command writes 512 bytes data to the specified log sector.
The 512 bytes data are transferred at a command and the Sector Count value shall be set to one. The
Sector Number shall be set to specify the log sector address as shown in the above figure. If the Read
Only log sector is specified, the device returns ABRT error.
11.42.1.8 SMART Enable Operations (Subcommand D8h)
This subcommand enables access to all S.M.A.R.T. capabilities within the device. Prior to receipt of a
SMART Enable Operations subcommand, Attribute Values are neither monitored nor saved by the
device. The state of S.M.A.R.T. (either enabled or disabled) will be preserved by the device across power
cycles. When enabled, the receipt of subsequent SMART Enable Operations subcommands will not
affect any of the Attribute Values.
Upon receipt of the SMART Enable Operations subcommand from the host the device enables
S.M.A.R.T. capabilities and functions and then saves any updated Attribute Values to the Attribute Data
sector.
11.42.1.9 SMART Disable Operations (Subcommand D9h)
This subcommand disables all S.M.A.R.T. capabilities within the device including the attribute Autosave
feature of the device. After receipt of this subcommand the device disables all S.M.A.R.T. operations.
Non-self-preserved Attribute Values will no longer be monitored. The state of S.M.A.R.T. (either enabled
or disabled) is preserved by the device across power cycles.
Upon receipt of the SMART Disable Operations subcommand from the host the device disables
S.M.A.R.T. capabilities and functions and then saves any updated Attribute Values to the Attribute Data
sector.
After receipt of the device of the SMART Disable Operations subcommand from the host all other
S.M.A.R.T. subcommands – with the exception of SMART Enable Operations – are disabled and invalid
and will be aborted by the device (including the SMART Disable Operations subcommand), returning the
error code as specified in Figure 169 on page 0.
Any Attribute Values accumulated and saved to volatile memory prior to receipt of the SMART Disable
Content
Log directory
Summary SMART Error Log
Extended Comprehensive SMART Error Log
SMART Self-test Log
Extended Self-test Log
Host vendor specific
Deskstar 180GXP hard disk drive specifications
192
Type
Read Only
Read Only
See Note
Read Only
See Note
Read/Write