Strong SRT 5020 User Manual page 14

• Manual Search
This option lets you search for a particular channel (or all channels from a specified
broadcaster).
h
Auto Searc ing
With the Auto Searching option highlighted, press OK on the remote control. (If Auto Searching is
not highlighted, press CH ▼or CH ▲ on the remote control.)
The SRT 5020 scans for channels and stations. As it finds them, it displays them (grouped by
broadcaster). When the scanning is complete, the Main Menu re-appears. Output from one of the
TV channels detected will appear on the menu screen. Press EXIT on the remote control to begin
normal viewing.
Manual Searching
NOTE: Auto searching (described above) is suitable in most cases. You might use
manual searching if you have deleted a channel and now want to access it again. In
this case, you would just search for that particular channel.
1. If the Main Menu is not displayed, press the MENU key on the remote control.
2. If the Scan option is not highlighted, press VOL
3. Press CH ▼or CH ▲ on the remote control to highlight Manual Scan.
4. Press OK on the remote control.
5. Select an option and enter the details of the channel you want to search for. (You can enter
the transponder frequency, channel number or bandwidth that identifies the channel you want
to search for).
NOTE: You press CH ▼or CH ▲ on the remote control to move from option to option. To
enter a new value, you either press the appropriate number keys on the remote control,
or press VOL or VOL
instructions on the screen indicate which method you must use.
6. When you have entered values that identify the channel you are searching for, press the SUB
button (the red button) on the remote control.
If the channel can be found, the details are shown on the screen and are saved.
7. Press MENU to return to the Main Menu or EXIT to return to normal viewing.
to decrease or increase the value already shown. The
or VOL on the remote control until it is.
14