Care And Cleaning; Metal Parts; Control Panel And Knobs - GE JMP28GR Use And Care Manual

Proper care and cleaning are important so your range will give you efficient
and satisfactory service. Follow these directions carefully in caring for your
range to assure safe and proper maintenance.
To clean the%t of the kick panel, wash with soap
and water. Rinse well.

Metal Parts

Do not use steel wool,
abrasives, ammonia or
commercial oven cleaners.
To safely clean surfaces;
wash, rinse and then dry
with a soft cloth.
Lift-Up Cooktop
Clean the area under the cooktop often. Built-up soil,
especially grease, may catch free. To make cleaning

Control Panel and Knobs

Clean up any spills or spatters with a damp cloth,
Remove heavier soil with warm, soapy water.
Clean control panel with mild liquid dish detergent
and a soft cloth. Rub control panel lightly.
CAUTION: Do not use abrasives of any kind on the
control panel. The lettering on models with touch pads
is sensitive to abrasives and pressure.
The control knobs may be removed for easier
cleaning. To remove knob, pull it straight off the stem.
Wash knobs in soap and water but do not soak.
24

CARE AND CLEANING

' J:;" -,
easier, the entire
cooktop may be lifted
up and supported in
the up position.
Do not use cleansing powders or harsh abrasives that
may scratch the surface.
Glass Surfaces
To clean the outside glass finish,
use a glass cleaner. Rinse and
polish with a dry cloth. Do not
allow the water or cleaner to run
down inside openings in the
glass while cleaning.
Be sure all surface units are turned off before
raising the cooktop. Grasp the front sides of the
cooktop and lift. The Calrod@ units do not need to
be removed before lifting.
After cleaning under the cooktop with hot, mild soapy
water and a clean cloth, lower the cooktop. Be careful
not to pinch your fingers.