GE Profile JMP31WAWW Specifications

TM
JMP31WAWW—GE Profile
Dimensions (in inches)
Important: This range is designed to hang from the
countertop. It does not rest on the floor.
Countertop
If necessary, build up
sides to 1-1⁄2" thick to
provide screw anchor
surface and
countertop support
24-3/16
22-3/16
27-1/8
2
22-3/16"
Back of range
20"
closed door
Door
clearance
Created 6/98
™ 27" Drop-In Electric Range
Trim section for
countertop with
post formed or
raised front
edge
Range side
support
30" MIN. to
bottom of
cabinet
over
range
18
28-1/2"
MIN.
28-7/16
27" Between
cabinets
Locate junction box
anywhere in shaded area
to front of
For answers to your Monogram,
GE Profile Performance Series,
GE Profile ™ or GE appliance questions, call
GE Answer Center
Listed by
Underwriters
Laboratories
R
13/32
®
™
® service, 800.626.2000.
Countertop Cutout Top View
Inside back wall of cabinet
or rear wall
1-1/2" MIN.
Clearance
3/8" MIN. Flat
Adjoining
vertical
22-7/8"
21-3/4" cabinet
cabinet
Cutout
face to rear
or wall
of cutout
above
countertop
26-1/4" MAX.
Smooth cut
3" MIN.
(Both sides)
*If countertop edge is formed, this
dimension must extend to flat area
In replacement installation, use
JX27R optional backguard, if required
Optional Backguard
KW Rating
(Available at additional cost)
240V 9.8 JX27RBK = Black
JX27RWH = White
208V 7.3
JX27RAD = Almond
Note: All 27" Drop-In Electric Ranges conform to U.L. requirements for min-
imum spacing between range and side walls above countertop.
Cabinets installed adjacent to slide-in ranges must have an adhesion spec
of at least 194°
Installation Information: Before installing, consult installation
instructions packed with product for current dimensional data.
23-3/8" MIN.*
Flat counter