Weider Pro 218 Manual page 9

10. Attach the Seat (22) to the Left Seat Bracket (64) and
the Right Seat Bracket (65) with four M6 x 16mm
Screws (45).
Insert the Seat Pin (63) through the holes in the cen-
ter of the Seat Brackets and the holes in the Bench
Frame (5).
Make sure the narrow end of the Seat (22) is
pointing towards the Backrest (23).
11. Press a 2" Square Inner Cap (29) into each end of
the Leg lever (3).
Insert the Weight Tube (20) into the indicated hole in
the Leg Lever (3) and secure it with an M8 x 60mm
Bolt (42), two M8 Washers (55), a 13mm Spacer (56)
and an M8 Nylon Locknut (40).
Press the 1" Round Angle Cap (57) onto the indicated
end of the Weight Tube (20). Press a 1" Round Inner
Cap (30) into the other end of the Weight Tube.
Slide the Weight Stop (21) onto the Weight Tube (20).
12. Lubricate the M10 x 70mm Bolt (41).
Attach the Leg Lever (3) to the bracket (E) on the
Front Leg (4) with the Bolt and an M10 Nylon Locknut
(49).
Attach the Leg Lever Lock (66) to the Front Leg (4)
with an M8 x 73mm Bolt (67), an 11mm Spacer (68),
an M8 Washer (55) and an M8 Nylon Locknut (40).
Do not overtighten the Nylon Locknut. You must
be able to freely pivot the Leg Lever (3) and the
Leg Lever Lock (66).
13. Press a 3/4" Round Inner Cap (31) into each end of
the three Pad Tubes (17 and 59).
Insert the Short Pad Tubes (17) through the holes in
the Leg Lever (3). Insert the Long Pad Tube (59)
through one set of holes in the bracket (E) on the
Front Leg (4).
Slide two Foam Pads (18) onto each Pad Tube (17
and 59).
10
22
63
5
11
29
30
21
20
12
49
3
13
18
31
18
31
17
31
9
64
65
45
29
3
57
40
55
56
29
4
E
40
41 Lubricate
68
55
66
59
E
31
4
3
18
23
55
42
67
18