Weider Pro 218 Manual page 11

17. Feed the Cable (36) through the indicated slot in the
Lat Tower (1). Rest the Cable in the groove of a
Pulley (35). Attach the Pulley to the Lat Tower with an
M10 x 75mm Bolt (50), two M10 Washers (51), two
15mm Spacers (52) and an M10 Nylon Locknut (49).
Rest the Cable (36) in the groove of the second
Pulley (35). Attach the Pulley to the Lat Tower (1) with
an M10 x 75mm Bolt (50), two M10 Washers (51),
two 15mm Spacers (52) and an M10 Nylon Locknut
(49).
Make sure the Cable (36) runs smoothly over both
Pulleys (35).
Attach the Cable (36) to the welded bracket (G) on
the Weight Carriage (2) with a Cable Clip (16).
18. Insert the Lat Tower (1) into the Front Leg (4). The
Lat Tower must be turned as shown. Secure the
Lat Tower with the Short Adjustment Knob (26).
17
50
52
35
52
36
16
G
18
1
4
11
52
50
51
51
49
Slot
1
2
26
35
52