Advertisement
Main Burner Ignitor Lighting
s
Do not lean over grill while lighting.
1. Turn OFF all Gas Burner Control Valves.
2. Turn ON gas source or tank.
3. Open lid during Lighting.
4. Push and turn main burner control knob to
in. You will hear a clicking sound as the burner is being
ignited. Ignition should occur within 5 seconds, but
continue to hold the knob in for a full 10 seconds to
maintain ignition.
5. Once burner has ignited, turn knob to desired setting.
6. If Ignition does NOT occur in 5 seconds, turn the burner
control to OFF, wait 5 minutes
repeat the lighting procedure.
7. Repeat steps 4 through 6 for the remaining main burners.
Searing Sideburner Ignitor Lighting
s
Do not lean over grill while lighting.
1. Open lid during lighting. Turn on gas at LP cylinder.
2. Push and turn control knob to
hear a clicking sound as the burner is being ignited.
Ignition should occur within 5 seconds, but continue to
hold the knob in for a full 10 seconds to maintain ignition.
3. Once burner has ignited, turn knob to desired setting.
4. If ignition does NOT occur in 5 seconds, turn the burner
control OFF. Wait 5 minutes
repeat the lighting procedure.
Rotisserie Burner Ignitor Lighting
s
Do not lean over grill while lighting.
1. Open lid during lighting. Turn on gas at LP cylinder.
2. Push and turn control knob to
hear a clicking sound as the burner is being ignited.
Ignition should occur within 5 seconds, but continue to
hold the knob in for a full 10 seconds to maintain ignition.
3. Once burner has ignited, turn knob to desired setting.
4. If ignition does NOT occur in 5 seconds, turn the burner
control OFF. Wait 5 minutes
repeat the lighting procedure.
WARNING
Turn controls and gas source or tank OFF when not
in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
8 • 464224011
and hold
for gas to clear away
, and
and hold in. You will
for gas to clear away
, and
and hold in. You will
for gas to clear away
, and
Match-Lighting
s
Do not lean over grill while lighting.
s
Open lid. Turn on gas at LP cylinder.
s
Light Burners one at time.
Match Lighting the Main Burners
1. Place match into match holder (hanging from right cart
side).
2. Strike the match and position lit match through match
light hole on RH side of cart. Shown Figure A.
3. Position lit match next to burner. Shown Figure B.
4. Push in and turn far right control knob to
Be sure burner lights and stays lit.
5. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF, wait 5 minutes
and repeat the lighting procedure.
6. Light other burners in sequence from right to left by
pushing knob in and turning to
Match Light
Hole
Figure A
Match lighting the Rotisserie Burner - Figure C
1. Place match in match holder. Strike the Match. Position lit
match close to the front center of the rotisserie burner.
2. Push in and turn rotisserie burner control knob to
sure burner lights and stays lit.
3. If ignition does NOT occur in 5 seconds, turn the burner
control knob OFF, wait 5 minutes
and repeat the lighting procedure.
Rotisserie Burner
Figure C
Match lighting the Searing Sideburner - Figure D
1. Place match in matchholder. Strike the Match. Position lit
match close to the Searing
burner.
2. Push in and turn Searing burner
knob to
position. Be sure
burner lights and stays lit.
3. If ignition does NOT occur in 5
seconds, turn the burner control
knob OFF, wait 5 minutes
gas to clear away
, and repeat
the lighting procedure.
position.
for gas to clear away
position.
Match shown next to burner
tube (under heat tent)
Figure B
for gas to clear away
Match holder
for
Figure D
,
. Be
,
Advertisement
