Advertisement
9
Remove the cap and nut from electronic ignition module. Attach electronic ignition module and heat
shield to cart left side panel with the nut, shown A.
Insert AA battery into ignition module, negative (-) end first. Then put on the cap, shown B.
Untie the 7 burner ignition wires bundled under the right side of grill head. Draw the wires over the cart
partition panel.
Connect each of the ignition wires from the main burner electrodes and sideburner electrode into the
back of the Electronic Ignition Module. Total (7) connections.
Untie the two wires [(a) and (b)] from under the left side of grill head. Connect the two wires [(a) and (b)]
from the switch wiring harness into the back of the Electronic Ignition Module. Total (2) connections.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in locations shown as
(a),(b).
Use one of the bundling ties to bundle the 9 wires together, and tie to the gas line hose so that the
wires don't hang down into the cabinet.
A
Nut
B
Cap
10
Insert front brace under control panel and between cart side panels. Secure using two 1/4-20x1¾" screws,
7mm lock washers and 7mm flat washers on each side, shown A.
Under front brace, secure cart partition panel to front brace using one #8-3/8" tapping screw, shown B.
7mm Lock washer
Qty.4
A
Electronic
ignition module
Heat shield
-
+
AA battery
7mm flat washer
Qty.4
#8-3/8" tapping screw
Qty.1
B
1/4-20x1¾"
Screw
7mm flat
7mm lock
Washer
Washer
4
1
(a)
5
2
6
3
7
(b)
.
1/4-20x1¾"screw
Qty.4
#8-3/8" tapping screw
464224011 • 19
Advertisement
