Advertisement
ASSEMBLY
1
Place bottom shelf upside down. Insert Bent U Pin into the caster mounting plate to lock it in place,
shown A. Spin the caster clockwise into the threads on the bottom shelf until secure. Remove the Bent U
Pin and repeat for remaining casters. Make sure the two locking casters are secured at the rear and the
non-locking casters are secured at the front. After all 4 casters are secure remove the Bent U Pin and
save for future maintenance.
Bent U pin
Qty.1
Bottom shelf
2
Attach side panels to bottom shelf using three
1/4-20x1/2" screws, 7mm lock washers and
7mm flat washers per panel.
IMPORTANT: Panel with large hole must
be on right side of bottom shelf.
Left side panel
Make sure side panels
are pushed as far to the
rear of bottom shelf as
possible before fully
tightening screws.
Locking caster
1/4-20x1/2" screw
7mm lock washer
7mm flat washer
Non-locking caster
7mm lock washer
Qty.6
1/4-20x1/2" screw
Qty.6
A
Bent U pin
7mm flat washer
Qty.6
Right side panel
(with large hole)
464224011 • 15
Advertisement
