Regency Ceiling Fans Regulator Owner's Manual page 2

G I
ENERAL NSTALLATION
I S
MPORTANT AFEGUARDS:
1. To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly
before beginning. before beginning.
2. To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring. All To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring.
electrical connections must be made in accordance with local codes, ordinances and/or the National Electric
Code. If you are unfamiliar with the methods of installing electrical wiring and products, secure the services of a
qualified and licensed electrician as well as someone who can check the strength of the supportive ceiling
members and make the proper installation(s) and connections.
3. Make sure that your installation site will not allow rotating fan blades to come in contact with any object. Blades
should be at least 7 feet from floor.
4. WARNING: WARNING: To reduce the risk of fire, electric shock, or personal injury, mount to outlet box marked
"Acceptable for Fan Support of 22.7 kg (50 lbs.) Or Less" and use mounting screws provided with the outlet box. "Acceptable for Fan Support of 22.7 kg (50 lbs.) Or Less"
Most outlet boxes commonly used for the support of light fixtures are not acceptable for fan support and may
need to be replaced. Due to the complexity of the installation of this fan, a qualified licensed electrician is
strongly recommended.
5. Blades should be attached after motor housing is hung and in place. Fan motor housing should be kept in the
carton until ready to be installed to protect its finish. If you are installing more than one ceiling fan, make sure
that you do not mix fan blade sets do not mix fan blade sets, as each blade is part of a weighted set.
6. After making electrical connections, spliced conductors should be turned upward and pushed carefully up into
outlet box. The wires should be spread apart with the common conductor and the grounding conductor on one
side of the outlet box, and the "HOT" wires on the other side.
7. Electrical diagrams are for reference only. Light kits that are not packed with the fan must be UL listed and
should be installed per the light kit's installation instructions.
8. After fan is completely installed, check to make sure that all connections are secure to prevent fan from falling
and/or causing damage or injury.
9. The fan can be made to work immediately after installation - the bearings are adequately charged with grease so
that, under normal conditions, further lubrication should not be necessary for the life of the fan.
10. Do not operate the reverse switch while the fan blades are in motion. The fan must be turned off and the blades
stopped before reversing the blades direction.
Weight of Fan: 30.89 Lbs
& O
PERATION
1
I
NSTRUCTIONS