Epson Stylus Pro 7600 Reference Manual page 54

LOAD PAPER
PAPER JAM
FRONT COVER OPEN
SET PAPER LEVER
PAPER NOT STRAIGHT
RELOAD PAPER
SET INK CARTRIDGE
INK OUT
NO INK CARTRIDGE
INK LOW
COMMAND ERROR
OPTION I/F ERROR
SERVICE REQ
MAINTENANCE
REQ
TURN PRINTER PWR OFF AND
THEN ON
SET INK LEVER
SUCTION The paper lever is set to the release
position, or roll paper is detected at the
paper insertion slot. Besides, suction
pressure can be set easily by the user.
Paper is jammed in the printer.
The front cover is open.
The paper lever is set to the release
position.
The paper is not loaded straight. (If PPR
ALIGN CHK (Paper Align Check) is ON.)
The printer cannot detect any paper.
Ink cartridge(s) is (are) defective or a
CSIC error has occurred.
CONTINUE? The INK OUT MSG is set to ON.
You are replacing the ink cartridge(s).
Ink cartridge(s) is (are) nearly empty.
Printout quality may decline when this
message is displayed.
Note:
If you continue printing in this status, print
out quality may decline.
This message is displayed when the
installed printer software is not correct
for you printer.
A Type-B I/F error has occurred.
XXXXXXXX A fatal error has occurred.
XXXX A part used in the printer has nearly
reached the end of its service life. Note
the error number "XXXX" and contact
your dealer. See "Contacting Customer
Support".
After cleaning jammed paper, this
message appears. Turn the printer off
and on.
The ink lever is set in the up position.
53