Epson Stylus Pro 7600 Reference Manual page 237

UNABLE TO PRINT
INK OUT
Y/LM/M/LC/C/K/LK
NO INK CARTRIDGE
Y/LM/M/LC/C/K/LK
WRONG CARTRIDGE
Y/LM/M/LC/C/K/LK
CSIC ERROR (TBD)
Y/LM/M/LC/C/K/LK
MAINTENANCE TANK
FULL
If an error occurs, or
the ink lever is at the
up position, you try to
print a test pattern
(nozzle check, status
check, head
alignment, or paper
thickness pattern)
from the SelecType
settings.
Ink cartridge(s) is
(are) empty.
Ink cartridge(s) is
(are) not installed.
Wrong ink
cartridge(s) is (are)
installed.
Ink cartridge(s) is
(are) not installed or
not attached
correctly.
Maintenance tank is
full with waste ink.
After 3 seconds the
message disappears.
Press the Pause button to
exit the SelecType mode.
When an error or status
message appears again,
clear and perform
printing a test pattern
again.
Replace the ink
cartridge(s) as indicated
by the lights. See
"Replacing Ink
Cartridges".
Install ink cartridge(s) as
indicated by the lights.
See "Replacing Ink
Cartridges".
Use the correct ink
cartridge(s).
Replace the ink
cartridge(s). See
"Replacing Ink
Cartridges".
Replace the
maintenance tank. See
"Replacing Black Ink
Cartridges".
236