Troubleshooting - NordicTrack Incline Trainer X7i Treadmill Manual

TROUBLESHOOTING

Most incline trainer problems can be solved by fol-
lowing the simple steps below. Find the symptom
that applies, and follow the steps listed. If further
assistance is needed, see the front cover of this
manual.
SYMPTOM: The power does not turn on
a. Make sure that the power cord is plugged into a
surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see
page 15). Use only a surge suppressor that meets
all of the specifications described on page 15.
IMPORTANT: The incline trainer is not compat-
ible with GFCI-equipped outlets and may not be
compatible with AFCI-equipped outlets.
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
c. Check the power switch located on the incline
trainer frame near the power cord. If the switch pro-
trudes as shown, the switch has tripped. To reset
the power switch, wait for five minutes and then
press the switch back in.
c
Tripped
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
Reset
26
c. Remove the key from the console, and then
reinsert it.
d. If the incline trainer still will not run, please see the
front cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a. The console features a display demo mode,
designed to be used if the incline trainer is dis-
played in a store. If the displays remain lit when
you remove the key, the demo mode is turned on.
To turn off the demo mode, hold down the Stop
button for a few seconds. If the displays are still lit,
see HOW TO CHANGE CONSOLE SETTINGS on
page 22 to turn off the demo mode.
SYMPTOM: The console does not display speed
and distance correctly
a. Remove the key from the console and UNPLUG
THE POWER CORD. Next, remove the three indi-
cated #8 x 1/2" Cover Screws (18) and the #8 x
1 1/4" Screw (36). Lift off the Left Roller Cover (38).
a
18
36
38
18