Table of Contents
Advertisement
Register User Telephone Number and Unit Name
This section describes the procedure for registering the user telephone number and unit name. For instructions
for entering information, refer to "Information About the Keys" below.
Information About the Keys
Use the keys shown below to enter information in the machine.
You can enter the following characters in each input mode:
The display returns to the standby mode:
●
The machine may enter the standby mode (Auto Clear function) while you are
setting it up. Make the setting again from the main menu.
The display turned off:
●
The machine may enter the sleep mode while you are setting it up. Press
[Power] to turn the machine back ON and continue the setup.
1
Press
[Additional Functions].
3 Make Fax Settings (imageRUNNER 1025iF Only)
Use – [numeric keys] to enter characters.
●
Press – [numeric keys] repeatedly until the
required character appears.
Press
to enter symbols.
●
Press
to switch between input modes:
●
<:a>: Letter mode
<:1>: Number mode
Press [
] or [
] to move the cursor
●
position.
Press
[Clear] to delete the character at the
●
cursor position. Press and hold
delete the entire entry.
Press [OK] to set the entry and to proceed to
●
the next screen.
2
Press [
] or [
SETTINGS>, then press [OK].
A D D . F U N C T I O N S
3 . T X / R X
3
Press [
] or [
then press [OK].
T X / R X
S E T T I N G S
2 . F A X
S E T T I N G S
[Clear] to
] to select <3. TX/RX
S E T T I N G S
] to select <2. FAX SETTINGS>,
15
Advertisement
Table of Contents
