Lamp Replacement - Sanyo PLC-XL45 Owner's Manual

Lamp Replacement

When the projection lamp of the projector reaches the end
of its life, the LAMP REPLACE indicator emits a yellow light.
If this indicator lights yellow, replace the lamp with a new
one promptly.
WARNING:
TURN OFF THE UV LAMP BEFORE
OPENING THE LAMP COVER
CAUTION
Allow the projector to cool for at least 45 minutes
before you open the Lamp cover. The inside of the
projector can become very hot.
Follow these steps to replace the lamp.
1
Turn off the projector and unplug the AC power cord.
Let the projector cool for at least 45 minutes.
2 Turn the projector over. Remove the screw that
secures the lamp cover, and then open the lamp cover.
3
Remove the two screws that secure the lamp. Lift the
lamp out of the projector by using the built in handle.
Replace the lamp with a new one and secure it with
4
the two screws. Make sure that the lamp is set
properly. Put the lamp cover back and secure it with
the screw.
5
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the lamp replacement counter.
See "Lamp Replacement Counter" on the next page.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following
information to the dealer.
Model No. of your projector : PLC-XL45
●
Replacement Lamp Type No. : POA-LMP10
●
CAUTION
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
(Service Parts No. 610 332 3855)
http://www.pureglare.com.au
Maintenance and Cleaning
Top Control
POWER WARNING LAMP REPLACE
This indicator turns yellow
when the projection lamp
reaches the end of its life.
Screw
Lamp Cover
Screw
Lamp
Screw
Handle
5