Sanyo PLC-XL45 Owner's Manual page 56

Appendix
Some displays are not seen during
the operation.
PIN code dialog box appears at
start-up.
Computer 2 cannot be selected.
The Terminal function cannot be
selected.
The Remote Control does not work.
Top Control does not work.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
If problems still persist after following all operating instructions, contact the dealer where you purchased the
projector or the service center. Specify the model number and explain about the problem. We will advise you
how to obtain service.
The CE Mark is a Directive
conformity mark of the European
Community (EC).
Pixelworks ICs used.
5
– Check the Display function (see page 41).
– PIN code lock is being set. Enter a PIN code; the "1234" or
numbers you have set (see pages 18, 47–48).
– Select Computer 2 in the Terminal function (see page 44).
– The Terminal function cannot be selected after Computer 2 is
selected. Select other input source such as Computer 1 or Video
with the COMPUTER button or the VIDEO button on the remote
control so that the Terminal function can be selected.
– Check the batteries.
– Make sure no obstruction is between the projector and the remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4' (5 m).
– Make sure the code of the remote control is conformed to that of
the projector (see page 46).
– Unlock the Key lock function for the remote control (see page 47).
– Unlock Key lock for the projector in the Key lock function. (See
page 47 .)
This symbol on the nameplate means the product
is Listed by Underwriters Laboratories Inc. It is
designed and manufactured to meet rigid U.L.
safety standards against risk of fire, casualty and
electrical hazards.
http://www.pureglare.com.au