Input Source Selection (Component, Rgb Scart 21-Pin) - Sanyo PLC-XL45 Owner's Manual

Input Source Selection (Component, RGB Scart 21-pin)

Direct Operation
Press the INPUT button on the top control or COMPUTER
button on the remote control to select Computer 1.
Before using INPUT or COMPUTER buttons, select the
correct input source through Menu operation as described
below.
Menu Operation
1
Use the MENU button to display the On-Screen Menu.
Press the Point buttons to move the red frame
7 8
pointer to the Input Menu icon.
2
Use the Point buttons to move the red arrow
ed
pointer to Computer 1 and then press the SELECT
button.
3
After the Source Select Menu appeared for Computer
1, move the pointer to Component or RGB (Scart) and
then press the SELECT button.
Component When the input source is coming from
video equipment connected to the
COMPUTER IN 1/COMPONENT IN
terminal with a Component-VGA Cable (not
supplied), select Component.
RGB (Scart) When the input source is coming from
video equipment connected to the
COMPUTER IN 1/COMPONENT IN
terminal with a Scart-VGA Cable (not
supplied), select RGB (Scart).
✔Note:
• Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is set as Monitor out (p.44).
• Computer 2 (COMPUTER IN 2/MONITOR OUT) can
accept only RGB signal.
• When the Input Search function is set On1 or On2, the
input signal will be searched automatically (p.45)
Top Control
Remote Control
*See Note at the bottom of this page.
Input Menu
http://www.pureglare.com.au
INPUT button
INPUT button
POWER WARNING LAMP REPLACE
Computer 1
Computer *
COMPUTER button
COMPUTER button
Computer 1
Computer *
Input Menu icon
Move the pointer (red arrow)
to Computer 1 and press the
SELECT button.
Computer
1
Source Select Menu
Move the pointer to Component
or RGB (Scart) and press the
SELECT button.
Video Input
Video
5