Sanyo PLC-XL45 Owner's Manual page 45

Input search
This function detects the input signal automatically. When
finding a signal, the search will stop. Use the Point
buttons to select one of the following.
Off ...... Input search does not work.
On1 ...... Input search works under the situation below.
• When the INPUT button on the top control is
pressed.
• When the COMPUTER button or VIDEO button
on the remote control is pressed.
On2 ...... Input search works under the situation below.
• When the projector is turned on with pressing
the POWER ON-OFF button on the top control or
on the remote control. (After the countdown)
• When the COMPUTER button or VIDEO button
on the remote control is pressed.
•When the current input signal is missed.✳
• When the INPUT button on the top control is
pressed.
✳ I f the No show or Freeze function is active, cancel it
to activate the Input search. It is not available when
On-Screen menu is displayed.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the input signal is interrupted and no
button is pressed for a certain period.
When the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display with
"No signal" appears. The countdown starts to turn off the
lamp.
Select one of the operations.
Ready......... When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp is turned on if the input
signal is reconnected or any button on the
top control or on the remote control is
pressed.
Shut down... When the lamp has been fully cooled
down, the power is turned off.
Off............ Power management function is off.
Then set the countdown timer with the Point
✔Note:
• Factory default is "Ready: 5 min. "
7 8
✔Note:
• While Input search is set On1 or On2, the
status of Input and Lamp are displayed
every time the signal is switched.
• Only the input source selected at the last
time can be detected.
• If any of the INPUT button on the top
control or COMPUTER/VIDEO button on
the remote control is pressed while Input
search is on, Input search will stop and go
back to the previous input sign.
Power management
Time left before Lamp is off.
buttons.
7 8
http://www.pureglare.com.au
Setting
Press the SELECT button
at Power management and
this box appears. Select
one of three settings with
the Point buttons, and
7 8
go to the timer with the
Point buttons and set
ed
time with the Point
7 8
buttons.
45