Assembly - NordicTrack Cxt 1100 User Manual

ASSEMBLY

Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the
included hex keys and your own phillips screwdriver
rubber mallet
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on
page 25. The second number refers to the quantity used in assembly. Note: Some small parts may have been
pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.
M8 x 19mm Button
M10 x 25mm Button
Screw (30)–4 Screw (109)–3
M10 x 43mm Button Screw (65)–4
1. Identify the Rear Stabiliser (59), which has Levelling
Feet (14) threaded into it. Attach the Rear Stabiliser to
the Frame (1) with the four M10 x 56mm Button
Screws (60) and four M10 Split Washers (22).
2. Attach the Front Stabiliser (90) to the Frame (1) with
the four M10 x 43mm Button Screws (65) and four
M10 Split Washers (22). Make sure that the Front
Stabiliser is turned so the Stabiliser Wheels (45)
are not touching the floor.
, and pliers
M8 Split
Washer (58)–4
M10 x 56mm Button Screw (60)–4
5
, adjustable spanner
.
M10 Split M8 Washer
Washer (22)–11
(33)–4
M10 x 36mm Carriage Bolt (61)–2
1
22
2
65
22
45
M10 Washer
(63)–2
60
60
22
1
59
14
65
22
1
90
,