NordicTrack Audio Rider R400 Bike User Manual page 6

5. The Console (4) requires four "D" batteries (not includ-
ed); alkaline batteries are recommended. IMPOR-
TANT: If the exercise cycle has been exposed to
cold temperatures, allow it to warm to room tem-
perature before inserting batteries into the
Console. If you do not do this, the console dis-
plays or other electronic components may become
damaged. Remove the battery covers from the back
of the Console. Next, insert four batteries into the bat-
tery compartments; make sure that the batteries are
oriented as shown by the diagrams inside the bat-
tery compartments. Then, reattach the battery cov-
ers.
Note: The Console (4) can be operated with an option-
al power supply instead of batteries. To purchase a
power supply, call the toll-free telephone number
on the front cover of this manual. Plug one end of
the power supply into the jack at the front of the exer-
cise cycle. Plug the other end of the power supply into
an appropriate outlet that is properly installed in accor-
dance with all local codes and ordinances.
6. Attach the Handlebar (39) to the Upright (2) with four
M6 x 30mm Button Screws (37).
7. While another person holds the Console (4) near the
Handlebar (39), connect the wire harness on the
Console to the Main Wire Harness (43). Next, connect
the pulse wire on the Console to the Pulse Wire (51) in
the Handlebar (39). Note: The remaining wire on the
Console is used during the manufacturing process;
disregard this wire.
Insert the excess wiring downward into the Upright (2).
Attach the Console (4) to the Handlebar (39) and the
Upright with four M4 x 16mm Round Head Screws
(80). Be careful to avoid pinching the Wires (43, 51).
5
Batteries
4
6
2
7
80
80
2
6
Battery
Covers
Batteries
37
37
39
Wire
Harness
43
4
Pulse
51
Wire
39
Avoid pinching
the Wires (43, 51)
during this step