NordicTrack Audio Rider R400 Bike User Manual page 5

2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (16) to the Frame with four
M8 x 50mm Button Screws (52) and four M8 Split
Washers (55).
3. Tighten the Upright Knob (7) into the Frame (1).
4. Have another person hold the Upright (2) near the
front of the Frame (1). Locate the wire tie (see the
inset drawing) in the Upright. Tie the lower end of the
wire tie to the Main Wire Harness (43). Next, pull the
upper end of the wire tie upward out of the top of the
Upright. Then, untie and discard the wire tie.
Attach the Upright (2) to the Frame (1) with an M10 x
63mm Bolt Set (62). Be careful to avoid pinching the
Main Wire Harness (43).
2
1
16
3
7
4
Avoid pinching
and damaging
the wires
2
62
5
55
55
52
52
1
43
Wire Tie
62
43
1