Cleaning - Kenmore 116.21714 Use & Care Manual

MANGO
El Cepillo de combinacion puede ser
almacenado en el mango de la manguera,
colocandolo en el mango antes de
conectar el tubo telescopico. Desliza el
cepillo de combinación firmemente dentro
del mango.
Mango
Cepillo para
combinación
Introduzca el tubo en el mango hasta que el
botón quede en posición. Asegúrese de que la
manguera no esté torcida.
Para retirar: Oprima el botón de liberación
rápida del mango para liberar el mango y
tire del mango hacia arriba.
Para Guardar: Para prevenir la presión de la
manguera mientras se guarda, desuna la
manguera del tubo de la aspiradora. Guarde
la manguera en una posición enrollada y floja
de tal manera que la tapa de la manguera no
se estire.
Botón de
liberación
Botón de
del tubo
liberación
del cepillo
Cepillo para
combinación
8
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your
vacuum cleaner, the agitator must be
cleaned every time the belt is changed.
The agitator must also be cleaned
according to the following schedule:
Vacuum Cleaner Use Clean Agitator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
LIGHT - every 2 months
(used 1 time/week)
IMPORTANT
Disconnect vacuum cleaner from electrical
outlet. Check and remove hair, string and
lint build-up frequently in the PowerMate
agitator and end cap areas.
Remove any dirt or debris in the belt
path area or in the brush roller area.
Carefully remove
any string or
debris located
on the agitator
or end caps.
AGITATOR ASSEMBLY
End Cap
Belt Path
End Cap
Brush Unit
TO REPLACE BELT
NOTE: Use replacement belt STYLE CB-3,
see part number detail in REPLACEMENT
PARTS (page 5).
1. Install new
belt over
motor drive,
then over
belt path.
Belt Path
End Cap
Agitator
2. Place agitator
assembly into
PowerMate .
3. NOTE: Be sure that the dirt sensor
board is positioned in slots and all wiring is
tucked back in place.
4. Line up front of cover and base. Rest
cover on front edge of base as shown.
5. Rotate cover
back. Press cover
firmly until side
latches snap into
place.
6. Make sure there is no gap between the
cover and base and that the rear latches
are snapped in place.
7. Turn PowerMate upside down and replace
four (4) cover screws.
25
Motor
Drive