Canister Care; Removing Clogs; Cleaning Exterior And Attachments - Kenmore 116.21714 Use & Care Manual

CANISTER CARE

REMOVING CLOGS

The vacuum cleaner creates suction that
picks up dirt. Rapidly moving air carries
the dirt to the dust bag through the airflow
passages. The dust bag lets the air pass
through, while it traps the dirt.
For best cleaning results, keep the
airflow passage open. Check the
starred (★) areas occasionally
for clogs. Turn off and unplug
vacuum cleaner from outlet
before checking.
TO CHECK FOR CLOGS:
· Check dust bag and change if full. See
DUST BAG CHANGING (page 21).
· Check motor safety filter and exhaust
filter and replace if dirty. See MOTOR
SAFETY FILTER CHANGING (page 22)
and EXHAUST FILTER CHANGING
(page 23).
· Check PowerMate for any dirt or debris
in the belt path area or in the agitator
area. Carefully remove any string or
debris located on the agitator or end
caps. See TO CLEAN AGITATOR (page
25).

CLEANING EXTERIOR AND ATTACHMENTS

1. Turn off and unplug vacuum cleaner. DO
NOT drip water on vacuum cleaner.
2. To clean exterior, or to reduce static
electricity and dust build-up, wipe outer
surface of vacuum cleaner and attach-
ments. Use a clean, soft cloth that has
been dipped in a solution of mild liquid
detergent and water, then wrung dry. Wipe
dry after cleaning.
Motor
Safety
Filter
Dust Bag
If the vacuum cleaner still has poor
suction, do the following:
1. Connect the hose to the canister and
turn vacuum cleaner on. Check the end
of the hose for suction. If there is good
suction on the hose handle, there is no
clog in the hose. If the suction is bad,
remove any dirt or debris in the hose
and handle.
2. Connect hose handle to wand. Check
the end of the wand for suction. If
there is good suction at the end of the
wand, there is no clog in the wand. If
the suction is bad, remove any dirt or
debris in the wand.
3. Check PowerMate swivel. Remove any
dirt or debris.
CAUTION
Do not use attachments if they are wet.
Attachments used in dirty areas, such as
under a refrigerator, should not be used
on other surfaces until they are washed.
They could leave marks.
20
CUIDADO
NO instale ni retire el mango ni los tubos
cuando la aspiradora esté encendida. Esto
podría causar chispas y dañar los contac-
tos eléctricos o control electronico.
ACCESORIOS DEL MANGO
NOTA: Si tiene instalada la
Exhaust
PowerMate, apague la aspiradora antes de
Filter
quitar el mango de los tubos.
1. Oprima el
botón de
liberación rápida
del mango para
liberar el mango
y tire del mango
hacia arriba.
2. Deslice el accesorio deseado con firmeza
sobre el mango. Consulte: CUADRO DE USO
DE LOS ACCESORIOS
Mango
Cepillo para
combinación
Mango
Cepillo para
pelo de animales
Mango
Herramienta
para hendiduras
ACCESORIOS
Pet PowerMate
Botón de
liberación
del tubo
NOTA:
Para remover el cepillo de combinación,
presione el botón liberador y sepárelo.
(pág 16).
Botón de
liberación
del cepillo
NOTA:
Para remover el cepillo de piso y/o el
cepillo para pelo de mascotas, presione
el botón liberador del tubo y sepárelo.
Botón de
liberación
del tubo
Botón de
liberación
del tubo
13
Mango
Cepillo
para pisos
Mango