Toshiba R410A Service Manual page 208

Part to be
No.
exchanged
3 Heat
exchanger
Before beginning the procedure, ensure the
refrigerant has been reclaimed from the
outdoor unit, using a suitable refrigerant
recovery device.
M Disassembling (Example):
1) Remove the cabinet.
2) Remove the motor base. (M5 × 10, 4 pcs.)
3) Remove the motor base bracket.
4) Remove the screws on the heat exchanger
5) Remove the screws on the support.
6) Remove the screws on waterproof board.
7) Remove the brazing section on the con-
8) Remove the screws on the support at the
Work procedure
REQUIREMENT
Wear protective clothing on your hands as
other components may cause and injury etc.
Heat exchanger (Right)
(M5 × 10, 5 pcs.)
fixing board. (M5 × 10, 6 pcs.)
(M5 × 10, 3 pcs.)
(M4 × 10, 3 pcs.)
nected pipe (8 positions).
rear side, and then pull out the heat ex-
changer. (M5 × 10, 2 pcs.)
Heat exchanger Heat exchanger Heat e xchanger
(Left) (Left) (Left)
7) Brazing section
(4 positions at header side)
8) Rear side 8) 8) Rear side
Draw it out it backwards.
(Draw it out forwards in case of a left
side heat exchanger.)
208
Remarks
2) Motor base
Heat exchanger Heat exchanger Heat e
(Right) (Right) (Right)
3) Motor base bracket
4) Heat exchanger 4) 4) Heat e Heat exchanger
fixing board fixing board fixing board
6) Waterproof board
7) Brazing section
(4 positions at distributor side)
Rear side
xchanger
5) Support
xchanger
8) Support