SECTION 13—BATTERIES
CAUTION
Only use a charger approved by Invacare when charging through the joystick on this
wheelchair model.
DO NOT use an independent charger with an output rating of over 8A (Amps).
Otherwise, damage may occur.
NOTE: For this procedure, refer to FIGURE 13.4 on page 65.
NOTE: The charger port located on the front of the joystick requires the use of an independent
charger.
1. Attach the battery charger connector to the charger port on the front of the joystick.
2. Plug the charger's AC power cord or extension into the grounded 110‐volt wall outlet.
3. When charging is complete, turn charger off.
4. Disconnect output cable from charger port.
Charger Port
FIGURE 13.4 Battery Charger Operation
65
Part No. 1143206
Pronto® M41 with SureStep®