Invacare Pronto M41 Owner's Manual page 49

NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Using the two socket bolts and locknuts, secure the telescoping front rigging support
to the seat frame as shown in FIGURE 10.6.
5. If necessary, repeat STEPS 2‐4 on remaining telescoping front rigging support.
6. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 38.
Seat
FRONT RIGGING
MODEL
PHW93
PH904A and PHAL4A
FIGURE 10.6 Adjusting/Replacing Telescoping Front Rigging Supports
Part No. 1143206
Locknuts
Spacers
Inner Mounting
Holes
STANDARD
POSITION
18 inches 20 inches
wide wide
Holes Holes
4 and 5 4 and 5
Holes Holes
3 and 4 3 and 4
49
SECTION 10—FRONT RIGGINGS
Mounting
Bolts
Telescoping Front
Rigging Support
8
7 6
5
4 3
2
Mounting Holes
1 INCH OUT
18 inches 20 inches
wide wide
Holes Holes
5 and 6 5 and 6
Holes Holes
4 and 5 4 and 5
Pronto® M41 with SureStep®
Hinge
Pins
Not
Used
2 INCHES OUT
18 inches 20 inches
wide wide
Holes Holes
6 and 7 6 and 7
Holes Holes
5 and 6 5 and 6