Model PH904A and PHAL4A
NOTE: For this procedure, refer to FIGURE 10.3.
NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.
1. Loosen, but do not remove the lug bolt
and locknut that secure the lower
footrest to the footrest support.
2. Reposition the lower footrest to the
desired height.
3. Securely tighten the lug bolt and
locknut that secure the lower footrest to
the footrest support.
4. Repeat STEPS 1‐3 for the opposite side
of the wheelchair footrest, if necessary.
Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE 10.4.
1. Note the position of hex bolt, coved
washers and locknut for reinstallation.
2. Remove the hex bolt, coved washers
and locknut that secure the lower
footrest to the footrest support.
3. Remove the lower footrest.
4. Remove the phillips
locknut that secure the existing heel
loop to the lower footrest.
5. Slide the existing heel loop off the
lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1‐6 to reassemble.
NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the
spacer is secure.
Part No. 1143206
®
bolt, spacer and
47
SECTION 10—FRONT RIGGINGS
Footrest
Support
Lug Bolt
Lower
Footrest
FIGURE 10.3
Adjusting Footrest Height -
Model PH904A and PHAL4A
Locknut
Locknut
Coved
Washer
Footrest
Support
Lower
Footrest
FIGURE 10.4
Replacing Heel Loops
Pronto® M41 with SureStep®
Locknut
Coved
Washer
Hex Bolt
Phillips
Bolt
Spacer
Heel Loop
Locknut