Performance And Lockup Problems - Lenovo ThinkCentre M93z Hardware Maintenance Manual

• If the failing option is a SCSI option, verify that:
– The cables for all external SCSI options are connected correctly.
– The last option in each SCSI chain, or the end of the SCSI cable, is terminated correctly.
– All external SCSI options are turned on. External SCSI options must be turned on before the computer
is turned on. For more information, see your SCSI documentation.
• Verify that the option and any required device drivers are installed correctly.
If these actions do not correct the problem, run the diagnostic programs (see "Lenovo Solution Center" on
page 53 for instructions). If you need technical assistance, see "Lenovo Support Web site" on page 31.

Performance and lockup problems

Poor performance and lockup problems can be a result of any of the following:
• "Insufficient free hard disk drive space" on page 49
• "Excessive number of fragmented files" on page 50
• "Insufficient memory" on page 50
Make a selection from the above list to find out more about the corrective actions you can take.
Insufficient free hard disk drive space
Symptom: Insufficient free hard disk drive space
The Windows operating system will slow down and might produce errors if the hard disk drive gets too full.
To check the amount of free space on the Windows 7 operating system, do the following:
1. Click Start ➙ Computer.
2. Right-click your C drive entry and then click Properties. The amount of free disk space is displayed.
To check the amount of free space on the Windows 8 operating system, do the following:
1. Open File Explorer and click Computer.
2. Right-click your C drive entry and then click Properties. The amount of free disk space is displayed.
To check the amount of free space on the Windows 8.1 operating system, do the following:
1. Open File Explorer.
2. Right-click your C drive entry and then click Properties. The amount of free disk space is displayed.
To free up disk space, do any of the following:
• Method 1
1. On the Windows 7 operating system, click Start ➙ Computer. On the Windows 8 operating system,
open File Explorer and click Computer. On the Windows 8.1 operating system, open File Explorer.
2. Right-click your C drive entry and then click Properties.
3. Click Disk Cleanup.
4. A list of unnecessary file categories is displayed. Select each file category you want to delete,
and then click OK.
• Method 2
1. Open Control Panel.
2. Click Programs.
.
Chapter 5 Troubleshooting and diagnostics
49