Replacing The Wifi Antennas - Lenovo ThinkCentre M93z Hardware Maintenance Manual

5. Note the power switch and control button board cable routing and disconnect the cable from the system
board. See "Locating parts on the system board" on page 74.
6. Remove the LCD bracket. See "Replacing the LCD panel" on page 119.
7. Remove the screws
Figure 55. Removing the power switch and control button board
8. Align the screw holes in the new power switch and control button board with the corresponding ones in
the front bezel. Then, install the screws to secure the new power switch and control button board to
the front bezel.
9. Connect the new power switch and control button board cable to the system board. See "Locating
parts on the system board" on page 74.
10. Reinstall the LCD bracket. See "Replacing the LCD panel" on page 119.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 127.

Replacing the WiFi antennas

Attention:
Do not open your computer or attempt any repair before reading and understanding "Important Safety Information"
on page 1.
This section provides instructions on how to replace the WiFi antennas.
1 to disengage the power switch and control button board from the front bezel.
.
Chapter 9 Replacing FRUs
125