HP Integrity Superdome 2 16-socket User Manual page 175

265 Certificate has not been mapped to this user account.
266 Two-Factor Authentication is in Effect. Please close the browser and try to login.
267 Two-Factor Authentication configuration was not changed.
268 An iLO image is already staged.
269 The file was not a proper iLO image.
271 Cannot delete the last CA with Two-Factor Authentication enabled.
272 The Onboard Administrator cannot communicate with iLO. Please Select iLO network
configuration.
273 An EBIPA configuration error occured.
274 Link Loss Failover Interval must be between 30 and 86400 seconds.
275 Network speed must be either 10Mbit or 100Mbit.
276 Network duplex setting must be Half or Full.
279 A firmware image is already staged.
280 The file was not a valid image.
281 Bad image CRC checksum.
282 Remote system logging must be enabled to perform this operation.
283 Invalid remote port. The port must be a number between 1 and 65535.
284 The remote syslog server address must be configured before enabling remote system logging.
285 Invalid remote server address.
294 There are no USB keys connected to enclosure.
295 No valid firmware images were found on the USB key.
296 No configuration scripts were found on the USB key.
297 I/O error on the USB key.
298 The USB file URL entered is not valid. USB config files must have a ".cfg" file extension and
must not contain any spaces.
299 Unable to access the USB media due to permissions.
300 Error uploading to USB media.
301 An invalid number of GUIDs was passed to the OA.
303 Invalid session timeout. Session timeout must be ten minutes or greater, and no more than
1,440 minutes (24 hours). Session timeout will be disabled if set to zero.
317 Invalid DNS hostname. DNS hostnames must not begin or end with a dash (-); they must only
consist of letters, numbers, and dashes; and they cannot be entirely numeric.
500 The action did not complete successfully.
502 Invalid response. No connection or network busy.
503 Web server busy or in service.
605 A partition with that name or number already exists.
606 Partition could not be created.
607 A partition with that name already exists.
608 A partition with that name or number already exists.
609 Invalid partition number.
610 Partition size limit exceeded. Either the maximum number of partitions for this system has been
exceeded or the maximum number of blades has been assigned to this partition.
61 1 This operation cannot be performed on a running partition.
Onboard Administrator error messages 175