Bracket Mounting Locations - HP Cluster Platform Hardware Kits v2010 Installation Manual

Figure 2-2 Bracket Mounting Locations
U10
U9
U8
U7
U6
The following list describes the callouts shown in
1. The U location that aligns with the top of the blades enclosure. Each enclosure is 10U high.
2. Filled squares – One of three potential cutouts (mounting holes) where you mount the
bracket's hook.
3. Circled squares – One of three potential cutouts where you locate a fastener.
Use the following procedure to determine the actual mounting locations for brackets:
1. Determine which of the interconnect module bays contain the InfiniBand switch.
Note:
There might be more than one InfiniBand switch module in some configurations.
2. Determine the rack U location that aligns with the top of the c-Class enclosure.
3. Using a pen or masking tape, mark the mount locations defined in
Table 2-1 Bracket Mount Locations
Interconnect Module Bay
Bay 3 and 4
Bay 5 and 6
Bay 7 and 8
12 Aligning the Bracket
1
2
3
Relative U Location
Third U down from the top
of the c-Class (c7000)
enclosure
Fourth U down from the top
of the c-Class (c7000)
enclosure
Fifth U down from the top of
the c-Class (c7000) enclosure
Figure 2-2:
Bracket Hook Cut-out
Bottom cutout
Center cutout
Top cutout
Table 2-1.
Fastener Cutout
Top cutout of the next U
location below (fourth U)
Bottom cutout
Center cutout