Advertisement
Closed defect summary
Deleting LSAN zones from the LSAN zoning scope
does not work for a fabric that is in the "McDATA
Open Fabric Mode".
Symptom—The customer see an error message which
says "Unable to activate the zones in the McDATA
Open Fabric Mode". As a result, the customer will not
be able to delete the LSAN zones from the fabric.
Online help for Set End to End Monitor dialog does
not mention the Refresh button in the dialog.
Symptom—The user does not get any information in
the online help content regarding the Refresh button
in the Set End To End monitors dialog.
If a user deletes all the tunnels and creates new
nl
tunnels, the older tunnel is shown in the switch
nl
properties of DCFM.
Symptom—Customer can see the older tunnel shown
in the FCIP tunnels tab of switch properties. If the user
needs to check the FCIP tunnel ID drop-down, that
tunnel is not shown.
The Call Home section in the PDF document needs to
be modified.
Symptom—The user will not get proper information
from the PDF document.
The functionality of 'Update' in the License dialog is
mentioned incorrectly in the online help and PDF
document.
Symptom—In the online help as well as in the PDF
document, the functionality of 'Update' in the License
dialog is mentioned incorrectly.
Some of the events mentioned in the Call Home event
tables section needs to be modified in the PDF
nl
documentation.
Symptom—User has wrong information regarding Call
Home events.
LUNs dialog is closing after a change in LUN settings.
Symptom—LUNs dialog closes after a change to the
LUNs.
Master log entry for Security violation has a last
nl
occurrence host time of Dec 31, 22:27.
Symptom—Unable to sort Master log to see the newest
entries as they occur because the Last Occurrence Host
Time is not correct.
Solution
Fixed in DCFM 10.1.0
Workaround—Manually delete all the LSAN zones
from the fabric through EOS.
Fixed in DCFM 10.1.0
Fixed in DCFM 10.1.0
Workaround—Delete the tunnel again from Switch
properties where the tunnel is created.
Fixed in DCFM 10.1.0
Fixed in DCFM 10.1.0
Fixed in DCFM 10.1.0
Fixed in DCFM 10.1.0
Workaround—Select the target container, and then
relaunch the LUNs dialog by clicking LUNs.
Fixed in DCFM 10.1.0
HP StorageWorks B-series Data Center Fabric Manager Enterprise
23
Advertisement
