Disabling An Ipv6 Vrrp Group; Displaying And Maintaining Ipv6 Vrrp; Ipv4 Vrrp Configuration Examples; Single Vrrp Group Configuration Example - HP 6125XLG Configuration Manual

Disabling an IPv6 VRRP group

You can temporarily disable an IPv6 VRRP group. After being disabled, the VRRP group stays in
initialized state, and its configurations remain unchanged. You can change the configuration of a VRRP
group when it is disabled. Your changes take effect when you enable the VRRP group again.
To disable an IPv6 VRRP group:
Step
1. Enter system view.
2. Enter interface view.
3. Disable an IPv6 VRRP group.

Displaying and maintaining IPv6 VRRP

Execute display commands in any view and the reset command in user view.
Task
Display the states of IPv6 VRRP
groups.
Display statistics for IPv6 VRRP
groups.
Clear statistics for IPv6 VRRP
groups.

IPv4 VRRP configuration examples

This section provides examples of configuring IPv4 VRRP applications on switches.

Single VRRP group configuration example

This section provides an example of configuring a single VRRP group on switches.
Network requirements
Switch A and Switch B form a VRRP group and use the virtual IP address 10.1.1.1 1 1/24 to provide gateway
service for the subnet where Host A resides, as shown in
Switch A operates as the master to forward packets from Host A to Host B. When Switch A fails, Switch
B takes over to forward packets for Host A.
Command
system-view
interface interface-type
interface-number
vrrp ipv6 vrid virtual-router-id
shutdown
Command
display vrrp ipv6 [ interface interface-type interface-number [ vrid
virtual-router-id ] ] [ verbose ]
display vrrp ipv6 statistics [ interface interface-type interface-number
[ vrid virtual-router-id ] ]
reset vrrp ipv6 statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
Figure
58
Remarks
N/A
N/A
By default, an IPv6 VRRP group is
enabled.
20.