Configuring The Router Priority, Preemptive Mode, And Tracking Function - HP 6125XLG Configuration Manual

When a router is the IP address owner in a VRRP group, do not configure the network command on
•
the interface to use the IP address of the interface, or the virtual IP address of the VRRP group, to
establish a neighbor relationship with the adjacent router. For more information about the network
command, see Layer 3—IP Routing Command Reference.
• If you create an IPv4 VRRP group but do not assign any virtual IP address for it, the VRRP group stays
in inactive state and does not function.
Removal of the VRRP group on the IP address owner causes IP address collision. To avoid the
•
collision, change the IP address of the interface on the IP address owner before you remove the
VRRP group from the interface.
The virtual IP addresses of an IPv4 VRRP group and the IP address of the downlink interface of the
•
VRRP group must be in the same subnet. Otherwise, the hosts in the subnet cannot access external
networks.
Configuration procedure
To create a VRRP group and assign a virtual IP address:
Step
1. Enter system view.
2. Enter interface view.
3. Create a VRRP group
and assign a virtual IP
address.
Configuring the router priority, preemptive mode, and tracking
function
The router priority determines which router in the VRRP group serves as the master. The preemptive mode
enables a backup to take over as the master when it detects that it has a higher priority than the current
master. The tracking function decreases the router priority or enables the backup to take over as the
master when the state of the monitored track entry transits to Negative.
Configuration guidelines
The running priority of an IP address owner is always 255, and you do not need to configure it. An
•
IP address owner always operates in preemptive mode.
If you associate a track entry with a VRRP group on an IP address owner, the association does not
•
take effect until the router is not an IP address owner.
Configuration procedure
To configure the router priority, preemptive mode, and tracking function:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the priority of the
router in the VRRP group.
Command
system-view
interface interface-type interface-number
vrrp vrid virtual-router-id virtual-ip
virtual-address
Command
system-view
interface interface-type
interface-number
vrrp vrid virtual-router-id priority
priority-value
51
Remarks
N/A
N/A
By default, no VRRP group exists.
Remarks
N/A
N/A
The default setting is 100.