HP 6125XLG Configuration Manual page 126

Figure 32 Network diagram
Configuration procedure
Create VLANs and assign corresponding ports to them. Configure the IP address of each VLAN
1.
interface as shown in
2. Configure a track entry on Switch A:
# Configure track entry 1 and associate it with the link status of the uplink interface VLAN-interface
3.
[SwitchA] track 1 interface vlan-interface 3
3. Configure VRRP on Switch A:
# Create VRRP group 1 and configure the virtual IP address 10.1.1.10 for the group.
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the priority of Switch A in VRRP group 1 to 110.
[SwitchA-Vlan-interface2] vrrp vrid 1 priority 110
# Configure to monitor track entry 1, and specify the priority decrement as 30.
[SwitchA-Vlan-interface2] vrrp vrid 1 track 1 reduced 30
4. Configure VRRP on Switch B:
<SwitchB> system-view
[SwitchB] interface vlan-interface 2
# Create VRRP group 1 and configure the virtual IP address 10.1.1.10 for the group.
[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.10
Verifying the configuration
After configuration, ping Host B on Host A, and you can see that Host B is reachable. Use the display
vrrp command to view the configuration result.
# Display detailed information about VRRP group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp verbose
IPv4 Virtual Router Information:
Running Mode
Total number of virtual routers : 1
Interface Vlan-interface2
Figure 32. (Details not shown.)
: Standard
121