Configuration Example; Configuring Wfq Queuing; Configuration Procedure - HP 6125XLG Configuration Manual

Step
1. Enter system view.
2. Enter interface view.
3. (Optional.) Enable
WRR queuing.
4. Configure group-based
WRR queuing.

Configuration example

Network requirements
Enable packet-based WRR on port Ten-GigabitEthernet 1/1/5, assign queues 0 through 3 to WRR
group 1, with their weights being 1, 2, 4, 6, respectively, and assign queues 4 through 7 to WRR group
2, with their weights being 1, 2, 4, 6, respectively.

Configuration procedure

# Enter system view.
<Sysname> system-view
# Configure WRR queuing on Ten-GigabitEthernet 1/1/5.
[Sysname] interface Ten-GigabitEthernet 1/1/5
[Sysname-Ten-GigabitEthernet1/1/5] qos wrr weight
[Sysname-Ten-GigabitEthernet1/1/5] qos wrr 0 group 1 weight 1
[Sysname-Ten-GigabitEthernet1/1/5] qos wrr 1 group 1 weight 2
[Sysname-Ten-GigabitEthernet1/1/5] qos wrr 2 group 1 weight 4
[Sysname-Ten-GigabitEthernet1/1/5] qos wrr 3 group 1 weight 6
[Sysname-Ten-GigabitEthernet1/1/5] qos wrr 4 group 2 weight 1
[Sysname-Ten-GigabitEthernet1/1/5] qos wrr 5 group 2 weight 2
[Sysname-Ten-GigabitEthernet1/1/5] qos wrr 6 group 2 weight 4
[Sysname-Ten-GigabitEthernet1/1/5] qos wrr 7 group 2 weight 6

Configuring WFQ queuing

Configuration procedure
To configure WFQ queuing:
Step
1. Enter system view.
2. Enter interface view.
Command
system-view
interface interface-type
interface-number
qos wrr { byte-count | weight }
qos wrr queue-id group { 1 | 2 }
{ byte-count | weight }
schedule-value
Command
system-view
interface interface-type
interface-number
47
Remarks
N/A
N/A
The default queuing algorithm on an
interface is byte-count WRR queuing.
Select an approach according to the WRR
queuing type.
By default, all queues are in group 1, and
the weights of queues 0 through 7 are 1, 2,
3, 4, 5, 9, 13, and 15, respectively.
Remarks
N/A
N/A