TDK Genesys User Manual page 52

J1 contact Signal name
J1-1 ENA_IN
J1-2 IF_COM
J1-3
N/C
J1-47
J1-8 LOCAL/
REMOTE
J1-9 VPGM
J1-10 IPGM
J1-11 VMON
J1-12 COM
J1-13 CV/CC
J1-14 ENA_OUT
J1-15 SO
J1-16 PS_OK
N/C
J1-1720
J1-21 LOC/REM
SIGNAL
J1-22 VPGM_RTN
J1-23 IPGM_RTN
J1-24 IMON
J1-25 P
Table 4-4: J1 Connector Terminals and Functions
Enable/Disable the power supply output by dry-contact (short/open)
with ENA_OUT.
Isolated Interface Common. Return for the SO control, PS_OK signal
and for the optional IEEE interface.
No Connection
Input for selecting between Local or Remote analog programming of
output voltage and output current.
Input for remote analog voltage/resistance programming of the
Output Voltage.
Input for remote analog voltage/resistance programming of the
Output Current.
Output for monitoring the power supply Output Voltage.
Control Common. Return for VMON, IMON, CV/CC, LOC/REM.
Connected internally to the negative local sense (-LS).
Output for Constant-Voltage/Constant-Current mode indication.
Enable/Disable the power supply output by dry-contact (short/open)
with ENA_IN.
Input for Shut-Off control of the power supply output.
Output for indication of the power supply status.
No Connection.
Output for indicating if the unit is in Local or Remote analog
programming mode.
Return for VPGM input.
Connected internally to the "-LS".
Return for IPGM input.
Connected internally to the "-LS".
Output for monitoring the power supply Output Current.
Output for current balance in parallel operation.
83-530-000 Rev J
Function
48
Section
5.8
5.7
7.2
7.17.4
7.17.4
7.6
5.9
5.8
5.7
5.10
7.3
7.1
7.4
7.5
7.1
7.4
7.5
7.6
6.2