TDK Genesys User Manual page 33

2.15. J1 CONNECTOR
J1-1
J1-2
J1-3
J1-4
J1-5
J1-6
J1-7
J1-8
J1-9
J1-10
J1-11
J1-12
J1-13
J1-14
J1-15
J1-16
J1-17
J1-18
J1-19
J1-20
J1-21
J1-22
J1-23
J1-24
J1-25
ENA_IN Enable/Disable Dry Contact with J1-14
IF_COM Isolated Interface Common. Return for SO, PS_OK
IF_COM Isolated Interface Common. Return for SO, PS_OK
N/C
N/C
N/C
N/C
LOC/REM Input for selecting between Local or Remote analog programming.
VPGM Input for remote analog voltage/resistance programming of the Output Voltage
IPGM Input for remote analog voltage/resistance programming of the Output Current
VMON Output Voltage Monitor
COM Control Common for VMON & IMON
CV/CC Output for Constant Voltage / Constant Current mode indication
ENA_OUT Enable/Disable Dry Contact with J1-1
SO Input for Shut-Off control of the output.
PS_OK Output for indication of the power supply status
N/C
N/C
N/C
N/C
LOC/REM Signal Output for indicating if the unit is in Local or Remote analog programming mode.
VPGM_RTN Return for VPGM J1-9; connected to Neg Output
IPGM_RTN Return for IPGM J1-10; connected to Neg Output
IMON Output for Current Monitor
P Output for Current Balance in Parallel Operation (One wire – Reference to
Negative Output)
29
83-530-000 Rev J