Service Code; Using Service Codes; Power Cycling - Philips Magic 5 User Manual

7 Turn the blue gear wheel forward to tension the ink
film. The ink film must not have any creases.
8 Close the device. Insert the paper tray in the opening
provided for it behind the paper feeder. Insert paper
again.

Using Service Codes

The service codes delete all the changed settings and your
device is reset to factory settings. It may be possible that the
device with the changed settings reacts differently than ex-
pected.
Using the Service Code
Only use the service code if this is absolutely neces-
sary. Many service codes also delete saved messages
and telephone book entries.
1 Press _, 45 and _.
General information
The time and date flash on the display.
Problems when faxing or printing
Faxes sent are of poor quality.
The device produces black lines when sending or printing. Clean the scanner and the document feed slot.
Copy is blank.
Printing is interrupted.
No printing
Documents are not properly fed.
2 Enter a service code:
7117—Deletes all changed settings and saved data.
The device is reset to factory settings and the initial instal-
lation process is started.
7140—Deletes all changed settings. Saved data and
telephone book entries remain intact.
7227—Deletes saved faxes, when there are prob-
lems with printing.
3 Confirm using _.
4 Dial using / SURE: YES .
5 Confirm using _.
If you have entered the incorrect code, you can
cancel the entry with SURE: NO .

Power Cycling

If a problem occurs that cannot be corrected with the in-
structions in this user manual (see also the help below), fol-
low the steps given here.
1 Pull out the power plug.
2 Wait at least ten seconds, then plug the power plug
back into the socket.
3 If the error occurs again, please contact our technical
customer service or your retailer. Follow the instruc-
tions on the display and on the error report.
You must check the time and date after a short power fail-
ure. Confirm using _.
Change the resolution from RESOL.: STANDARD to
RESOL.: FINE or RESOL.: PHOTO .
Change the contrast.
Clean the scanner and the document feed slot.
Test the device by making a copy of the document. If the
device is in order, the fax machine of the recipient is defec-
tive.
Insert the documents face down into the document feeder.
Paper or document jam, no paper or ink film. Follow the
instructions on the display and in the error report.
There could be a small pause after printing several pages.
The device continues printing automatically.
Check if you have inserted clamped paper correctly. The
lever on the right hand side next to the paper feeder must
be folded backwards.
Clean the scanner and the document feed slot.
45