Wool Program - Daewoo DWD-WD1132 Owner's Manual

2. WOOL PROGRAM

Put the laundry into the Drum and put the detergent and softerner into the detergent
case.
1
Then close the Door.
• Put the detergent into the main wash room(I I marking) in the detergent case.
• Liquid detergent, Softner and Bleach should be below 'MAX' level.
Press the Power button.
2
• The LED shows only '- --' signal.
Select the 'WOOL' program using the program selection dial.
• If you press 'Start/Pause' button aftrer pressing Power button without selecting
program, the 'Cotton' program is selected as default program.
3
• 'Cold/Cold' water temperature and 'Light' soil level and 'Main Wash' and '1' time rinse
and 'Low' spin speed are selected automatically.
• If you want to change the 'Spin Speed' and 'Beeper', select program what you want to
change by pressing each button.
Press the 'Start/Pause' button.
4
• The washer will be operated with locking Door and supplying water after sensing the
amount of laundry automatically.
Note
• If you want to change the setting program during operation, press the 'Start/Pause' button to hold the operation
and change the program you want to change by pressing each corresponding button.
• Water Temperature 'Cold/Cold' is only selected, in order to prevent clothes from damaging.
• 'Time Delay' is not selected.
• Soil Level 'Light' is only selected, in oreder to prevent clothes from damaging.
• Spin speed 'no spin'~'Low' are only selectable.
17