HOW TO CLEAN THE FILTER
Cleaning the water inlet filter
Clean the filter when water leaks from the water inlet.
$ Pull the power plug out
before cleaning it.
Cleaning the drain filter
• This drain filter is used to screen the foreign stuffs such as threads, coins, pins, buttons etc..
• If the drain filter is not cleaned at proper time(every 10 times of use), drain problem could be caused.
CAUTION : Be careful when draining if the water is hot.
$ Open the lower cover(1) by using
a coin. Remove the cap hose(2)
to pull out the hose.
Cleaning the detergent case
After a while detergent and fabric softeners leave a deposit in the case;
- It should be cleaned from time to time with a jet of running water.
- If necessary it can be removed completely from the machine by pressing the catch downwards
and by pulling it out.
- To facilitate cleaning, the upper part of the fabric softener compartment can be removed.
• Detergent can also accumulate inside the recess which should be cleaned
occasionally with a brush.
• Once you have finished cleaning, replace the case and run a rinse cycle
without laundry.
% Turn off the water
supply to the washer
and separate the inlet
hose.
% Unplug the cap hose(2), allowing
the water to flow out. At this time
use a vessel to prevent water
flowing on to the floor.
When water does not flow any
more, turn the pump filter(3) open
to the left.
31
& Pull the inlet filter out.
& Remove any foreign material
from the pump filter(3).
After cleaning, turn the pump
filter clockwise and insert the cap
hose(2) to the original place.
Close the lower cover.
( Remove the dirt from
the inlet filter with a
brush.