Connecting The Tape Drive To An External Sas Port; Connecting The Sas Cable To The Server - HP StorageWorks User Manual

WARNING!
The supplied power cord is HP approved for your specific geographic region. Use of a non-HP
approved power cord may result in: 1) not meeting individual country specific safety requirements;
2) insufficient conductor ampacity that could result in overheating with potential personal injury and/or
property damage; and 3) an unapproved power cord could fracture resulting in the internal contacts
being exposed, which potentially could subject the user to a shock hazard. HP disclaims all liability
in the event a non-HP approved power cord is used.

Connecting the tape drive to an external SAS port

1. If installing a new HBA, follow the instructions supplied with the HBA to install it and its driver.
2. Connect the supplied SAS cable to the external SAS connector on the host SAS controller or new
HBA.
1. SAS connector on server
Figure 24 Connecting the SAS cable to the server
.
38 Installing an external Ultrium tape drive