Other Servers; Install Drive - All Servers; Attaching Locating Screws In A Typical Hp Proliant Ml350 Or Ml370 - HP StorageWorks User Manual

Use a T8 Torx screwdriver to attach the appropriate screws. Locate both screws lightly in position
before tightening, as shown in
HP ProLiant ML350: Use the metal shims and screw pack labeled 'ProLiant ML350'. These have
a thicker head than the general mounting screws.
HP ProLiant ML370: Use the metal shims and screw pack labeled 'ProLiant ML370'. These have
a thick offset piece and a thicker head than the general mounting screws.
1. 6 mm M3 mounting screws
2. 6 mm M3 offset mounting screws
Figure 7 Attaching locating screws in a typical HP ProLiant ML350 or ML370
.

Other servers

Attach the appropriate mounting hardware. Refer to the manufacturer's documentation for instructions.
If you are installing on a server that requires a tray, place the tape drive in the tray.
Some servers have snap-on mounting rails attached to the filler panel. These can be removed and
attached to the tape drive with screws.

Install drive - all servers

NOTE:
If cable access for the tape drive bay is awkward, it may be easier to access power and other
connections if the tape drive is installed in the top bay. You may need to move other devices to lower
bays to achieve this. Refer also to your server documentation.
Slide the tape drive into the open bay, aligning the tray or rails with the slots in the bay, as shown
in Figure 8 on page 24.
Figure 7 on page 23.
Ultrium Half-Height SAS Tape Drives 23