Info Screen - Respironics REMstar User Manual

• Flex - This displays the Flex level set by your home care provider. "Flex" will display as the current Flex setting
chosen by the provider. Your home care provider will either enable, lock, or disable Flex. If Flex is enabled and the
setting is not comfortable, you can increase or decrease this setting. If your provider has locked a Flex setting into
place, you can view the setting but cannot change it, and the screen will display a lock symbol. If your provider has
disabled Flex, you will not see this setting.
• Humidifier - This displays the humidifier setting. This will only display if the humidifier is attached. Please refer to
the humidifier manual if using a humidifier.
• Ramp Start - This displays the ramp starting pressure. You can increase or decrease the ramp starting pressure in
0.5 cm H O increments. This is only available if Ramp time has been set to >0 and auto min or CPAP pressure >4
2
cm H O. This will not display if your provider enabled Split night on your device.
2
• SYSTEM ONE resistance (
specific Respironics mask. Each Respironics mask may have a "System one" resistance control setting which will
appear next to the symbol (ex.
your mask. If your provider has locked the resistance setting into place, you can view the setting but cannot change it,
and the screen will display a lock symbol. If your provider has disabled resistance, you will not see this setting.
• Auto on - You can enable this feature if you want the device to automatically turn the airflow on whenever you
apply the interface (mask) to your airway.
• Auto off - You can enable this feature if you want the device to automatically turn the airflow off whenever you
remove the interface (mask) from your airway.
• Mask alert - You can enable or disable the mask alert setting. If this feature is enabled, the mask alert will appear
on the display screen when a significant mask leak is detected, and an audible alert will sound. Refer to the Device
Alerts section for more information about the mask alert.
• LED backlight - You can enable or disable the LED backlight for the humidifier icon and settings on the device.

info Screen

From the Home screen, highlight the "Info" option and press the wheel. The following Info screen will appear. The user
cannot change settings in the Info menu.
note: These screens are only for reference. Your home care provider may periodically ask you for this information.
Compliance VIC
Days > 4
info Screen
note: The screen will only show 4 lines at a time. As you rotate the Wheel to toggle over different options the
screen will slide up and down accordingly.
• Status - This displays information sent from a peripheral (SD card, modem, etc.). If two peripherals are attached,
two lines will appear with corresponding icons.
User Manual
) - This setting allows you to adjust the level of air pressure relief based on the
X3). Contact your home care provider if you cannot find this resistance setting for
9