Replacing The License Plate Light Bulb (Depens On Models); Replacing The Auxiliary Light Bulb (Depens On Models) - Yamaha Neo's YN50 Owner's Manual

Replacing the license plate
light bulb (Depens on
models)
1. Remove the lens by removing the
screw.
1. Screw
2. License plate light bulb socket
2. Remove the burnt out bulb by
pulling it out.
3. Insert a new bulb into the socket.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise
the lens may break.
PERIODIC MAINTENANCE AND ADJUSTMENT
EAUS1151
Replacing the auxiliary light
bulb (Depens on models)
If the auxiliary light bulb burns out,
replace it as follows.
1. Place the vehicle on the centers-
tand.
2. Remove cowling A. (See page
6-6).
3. Remove the auxiliary light socket
(together with the bulb) by pulling
it out.
1. Auxiliary light bulb socket
[ECA11191]
4. Remove the burnt-out bulb by
pulling it out.
EAU45462
1. Auxiliary light bulb
5. Insert a new bulb into the socket.
6. Install the auxiliary light socket
7. Install the cowling.
6-24
(together with the bulb) by pus-
hing it in.
6